Head material	Soft iron
Head manufacturing method	Lost wax precision casting + face laser milling
finishing	Tour Satin
Loft angle (°)	50	52	54	56	58	60	64
Bounce angle (°)	8	8	Ten	Ten	8	8	8
Lie angle (°)	64
Face progression (mm)	5.9	5.9	6.1	6.1	6.1	6.1	6.1
Club Length (inches)	35.125 to 35.375		35.0 to 35.25		34.875～35.0
grip	Tour Velvet full rubber grip (no backline, with logo) <49.5g/caliber 60>

●MADE IN JAPAN ●New groove rule compliant model

*Since emphasis is placed on spin performance, the ball may get scratched.

*The bend angle is the effective angle based on our own unique measurement method. Therefore, it may differ from the value obtained by general measurement methods.





Dynamic Gold EX Tour Issue
New "Weight Lock" technology provides the same performance for all players

Previously, Tour Issue irons were roughly divided into three groups based on the weight of each individual iron, and were selected so that the tolerance between sets within each group was within the regulations. However, even if the same S200 Tour Issue set was used, there was actually a slight weight difference when comparing sets from different groups. In other words, the weight tolerance between the iron sets I own is the same, but the basic weight is different when comparing your Tour Issue irons to my Tour Issue irons.

The new "Weight Lock" technology, for which a patent is pending, has been developed to eliminate the weight tolerances between sets that arise due to individual differences.

"Weight Lock" technology is a technology that eliminates individual differences in manufacturing by attaching a special material weight inside the shaft according to the difference from the basic weight. Of course, it is attached in a place that does not affect the flex, kick point, or performance of the shaft itself. Dynamic Gold EX Tour Issue, which was one of the first to adopt this technology, achieves tighter weight tolerances on the manufacturing line and at the same time, by attaching a "weight lock", all shafts are finished as products with the same specification weight and tolerance. In other words, it means that it is a "Tour Player Weight Shaft" that provides the same performance to all players, regardless of whether they are professional or amateur.

	flex	Product Manager	Weight before cutting (g)	Butt diameter (mm)	Tip diameter (mm)	Kick Point
DGIX- WL-HTX1	X100	40.5-37.0 inches (1029-940mm)	132	15.25	9.00	Original condition
DGIS- WL-HTS2	S200		131

Suitable head speed: 46m/s~(X), 40~48m/s(S)

Application: Iron, Dip: Tapered

*There is a "weight lock" attached to the inside of the shaft, so please do not press the inside with a stick or anything else. This may damage the "weight lock."
*Please do not use solvents such as paint thinner to wipe the printed surface as this may cause the print to peel off. Please also note that the print may peel off depending on the usage conditions or over many years of use.