【Notes】 ■ Delivery time is about one week. It may take longer if parts are out of stock.
■The sleeve and finished length will vary depending on the head you choose.
■The length is measured according to manufacturer standards and is the total length including the head.
■The sleeve is installed in the standard position.
■The shaft is a reverse insert with the logo on the back. If you have any preference, please write it in the comments section.
■Please note that balance adjustments are not possible.
■Please note that changes or cancellations cannot be made after the order has been confirmed.
Pin driver compatible
PING Sleeved Shaft Fujikura Jewel Line Platinum Speeder
(PLATINUM Speeder) For drivers
Item Number
pingss-25
[
550
Points awarded ]
-
-
-
-
-
-
-
-
-
-
*Sales prices at physical stores may vary depending on fitting, etc.
*We do not accept discount negotiations at physical stores when comparing online prices.
PING genuine sleeve
(Note) Please check the compatible clubs before purchasing.
G 410 Series Mounting Model
|
[Compatible clubs]
■G410 Driver (2019)
*Not compatible with the old model G Series (2016)
|
G Series (2016) installed model
|
[Compatible clubs]
■G400 Driver ■G Driver ■G30 Driver
|
*Cannot be installed on i25 Driver・FW, G25 Driver, ANSER Driver・FW (2013).
The strongest playing style has evolved even further
|
This is the world's first application of ultra-high modulus 90t carbon to the entire length of a golf shaft.
By suppressing shaking during the swing, it becomes much easier to swing, and by reducing impact loss, it gives you an unprecedented feeling of release.
Ultra-high elastic carbon fiber "90t carbon" By layering the world's hardest material, 90t carbon, we have achieved maximum acceleration and impact strength.
By suppressing shaking during the swing, it becomes much easier to swing, and by reducing impact loss, it gives you an unprecedented feeling of release.
Toray's cutting-edge carbon fiber "TORAYCA M40X" exceeds T1100G
Full-length laminate, just like the DAYTONA SPEEDER.
By pursuing both fiber strength and elastic modulus, which are in a trade-off relationship, to the limit, we have achieved an approximately 30% increase in strength while maintaining the same elastic modulus as conventional carbon fibers.
It produces a superior playing feel and feeling.
Ultra-low resin carbon sheet "RC15% prepreg" 40g/50g/60g
A carbon sheet with an ultra-low resin content of "RC15%", which has been further reduced to the bare minimum from RC20%, is laminated.
By reducing the amount of resin, the ratio of carbon fiber is increased, resulting in a dense shaft.
Wasted movement is eliminated, resulting in stronger spring back.
