【Notes】 ■ Delivery time is about one week. It may take longer if parts are out of stock.
■The sleeve and finished length will vary depending on the head you choose.
■The length is measured according to manufacturer standards and is the total length including the head.
■The sleeve is installed in the standard position.
■The shaft is a reverse insert with the logo on the back. If you have any preference, please write it in the comments section.
■Please note that balance adjustments are not possible.
■Please note that changes or cancellations cannot be made after the order has been confirmed.
| Recommended tune-up list |
| |
 |
glass coating |
| effect |
| Prevent scratches on the club |
| Estimated delivery date |
| Approximately 2 days |
| ▲Click on the image for details |
Progress Driver Compatible Products
BB4/BB6 Sleeved Shaft Fujikura
JEWEL LINE
DIAMOND Speeder
Item Number
bb4drss-fujidspdr
-
Custom (estimated delivery time: about 1 week)
[
600
Points awarded ]
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Quantity in stock
999
*Sales prices at physical stores may vary depending on fitting, etc.
*We do not accept discount negotiations at physical stores when comparing online prices.
Progress Driver Compatible Products
Special sleeve shaft
|
| Add some sparkle to every swing
|
Fujikura
DIAMOND SPEEDER
The Fujikura Diamond Speeder series, which achieved unprecedented low torque, has been upgraded with new materials to achieve even lower torque. We have also added a lightweight lineup so that many golfers can experience it.
Toray's "TORAYCA® MX Series M46X", which combines high elasticity and high strength, is used for the first time in a golf shaft. In addition to the "M40X" used in the DAYTONA SPEEDER, the cutting-edge material "M46X" is double-laminated, which combines ultra-high strength and high elasticity. The acceleration and impact strength exceed those of the previous model, resulting in an even higher initial ball velocity.
Low torque design The Outer Bias Technology has been upgraded to achieve lower torque than the previous model.
The proportion of highly elastic material used has been increased by more than 30%, achieving the lowest torque in FUJIKURA history.
CPM flow optimization The CPM flow has been optimized to make it easier to set up a complete set from driver to irons.
