Super Monster UT's long-awaited debut
[Specially-made custom clubs]
Music
On the Screw DU2 HEAVEN Utility
TRPX HYBRID
TRPX Hybrid Shaft
Item Number
du2ut-trpxhy
-
Custom (estimated delivery time: about 1 week)
List price
¥
74,800
at the place
¥
70,400
tax included
[
640
Points awarded ]
-
-
-
-
-
-
-
-
-
-
-
-
-
-
loft angle
Expected shipping date
*Sales prices at physical stores may vary depending on fitting, etc.
*We do not accept discount negotiations at physical stores when comparing online prices.
The long-awaited debut of Super Monster UT.
muziik muziik DU2 HEAVEN Utility |
Compared to the previous DU model, the overall face is cleaner.
The face gives the impression that it is easy to hold.
The sole is equipped with a heavier stainless steel plate than the previous model.
The center of gravity has been lowered by 4.7 mm, resulting in a lower center of gravity.
The same non-rotating sleeve as the DD2 and DF2 shafts is used.
The loft and lie can be adjusted.
Easy to hold and deep back shape for hitting |
The shape is easy to set up, with beautiful curves from the face to the crown and back face.
The deep back structure allows you to hit the ball just like an iron, reducing energy loss.
This also leads to an increase in initial velocity. Furthermore, it is well-known for its resilience and good feel.
DAT55G titanium is used for the face.
This is a utility that achieves distance comparable to that of a fairway wood.
※Matte finish
Stainless steel sole plate and adjustable screws |
Like the previous model, the stainless steel sole plate is removable (#3/75g, #4/81g)
Equipped with 4 Phillips head screws weighing 10g each.
The screws are also available separately in 3.5g, allowing you to adjust the weight.
Uses a FW-specific sleeve that prevents the shaft from rotating. |
Like the DD2 and DF2, it uses a sleeve that does not rotate the shaft axis.
There are four loft settings: -1°, standard, +1°, and +2°.
There are two lie angles available: standard and DRAW (+1° upright).
A total of eight different settings are available.
*The sleeve cannot be used with DD2 or DF2.
Head price: 60,000 yen + tax
(Sold separately) Dedicated head cover 3,000 yen + tax
(Sold separately) Head sleeve wrench 3,000 yen + tax
(Sold separately) Special sleeve 4,000 yen + tax
(Sold separately) Weight 3.5g 1,000 yen + tax *Standard is 2.5g x 4
*Cannot be removed with a special wrench for sleeves
The ratio of "shock-resistant material" and "high-flexibility material" is controlled by weight range. The "Performance Flow Design" adopted in the previous utility shaft has been further clarified.
The distribution of "impact-resistant material" and "high-flexibility material" is controlled by weight.
In the 50g range, a lot of "shock-resistant material" is used to enhance high launch and high repulsion.
As the weight range increases, the allocation of "high-bending material" increases, providing greater control over the height and distance of the launch, resulting in maneuverability similar to that of an iron.